English
17
ADDISH (option to add dishes after the pro-
gramme has started)
When the programme starts, you should only open
the door and add more dishes when the ADDISH
indicator light is switched on. The appliance will stop
automatically and the time remaining to the end of the
without
pressing any buttons.
Open the door slowly and carefully, to avoid get-
ting splashed by washing water.
Adding dishes after the ADDISH indicator light has
switched o is strongly discouraged as this could
aect the wash performance.
WARNING: If you open the door during the
drying cycle, an intermittent audio signal
advises you that the drying cycle has not yet
Interrupting a programme
Opening the door when a programme is running is
not recommended especially during the main wash
opened while a programme is running (for example, to
add dishes) the machine stops automatically.
Close the door, without pressing any buttons.
WARNING: If you open the door during the
drying cycle, an intermittent audio signal
advises you that the drying cycle has not yet
Changing a running programme
If you want to cancel and change a programme
that is already in progress, proceed as follows:
1 Press and hold the “RESET 3 SEC” button
for at least 3 seconds.
2 The countdown appears on the display “3
-2 -1” while the “RESET 3 SEC” button is
held down.
2 “RESET” will appear on the display and
beeps will sound.
4 The programme in progress will be can-
celled and the “ECO” program appears on
the display.
6 At this point you can set a new pro-
gramme using the “PROGRAMME SELEC-
TION” keys.
WARNING: Before starting a new pro-
gramme, you should check that there is still
detergent in the dispenser. If necessary, top
up the detergent.
3
5
Options and settings
Programme Water consumption (l) Electricity consumption (kWh)
9,3 9,5
13,4 14,6
12,6 12,6
13,4 14,6
16,6 18,1
14,2 15,1
13,4 14,6
4,6 4,6
1) The pressure and the tempera-
ture of the water, the variations
of the mains supply, the options,
the quantity of
dishes and the degree of soil can
change the values.
2) The values for programmes
other than ECO are indicative
only.