ERROR MESSAGES
178 LDC-3900 Series
CHAPTER 5
E-519 Setting a measurement is only valid during the calibration phase for that measurement.
User has tried to calibrate a measurement without first entering the required calibration
mode.
E-520 User cannot change the Laser Current set point while operating in a calibration mode for
another measurement.
E-533 Attempted to perform an operation which the LASER channel was not capable.
E-534 Change of a LAS limit value forced an update of the corresponding LAS set point.
Table 5.2 LDC-3900 Modular Laser Diode Controller Error Message Codes
Error Code Explanation
To Next Page
Loading...
Need help?
General
