ILX Lightwave LDC-3900 User Manual

REMOTE OPERATION
Common Commands and Queries
10_15 LDC-3900 Series 57
CHAPTER 3

The syntax for the *RST command is:
*SAV
The Save command stores the current state of the LDC-3900 in non-volatile local
memory. A particular state is then recalled by using the *RCL recall command
(see *RCL on page 55). There are 10 unique states which can be stored. The
syntax of the *SAV command is:
-where the data value must round off to an integer between 1 and 10. The
rounded integer value corresponds to a unique saved state which can be recalled
by using the same value with the *RCL command.
*SRE
The Service Request Enable command sets the Service Request Enable Register
bits to allow the LDC-3900 to generate the user-selectable service requests.
: *
RST
<white
space>
: *
PROGRAM DATA>
<DECIMAL
NUMERIC
SAV

ILX Lightwave LDC-3900 Specifications

General

Brand	ILX Lightwave
Model	LDC-3900
Category	Controller
Language	English