REMOTE OPERATION
ANSI/IEEE-488.2 Definitions
10_15 LDC-3900 Series 41
CHAPTER 3
MESSAGE TERMINATOR>, while the <CR> is treated as <white space>
(ignored). The LDC-3900 Modular Controller will accept any <PROGRAM
MESSAGE TERMINATOR> shown in Figure 3.2 on page 41. The LDC-3900
Modular Laser Diode Controller terminates its responses with a <NL><^END>
(unless the user changes the terminator via the TERM command).
Figure 3.2 <PROGRAM MESSAGE TERMINATOR> Syntax Diagram
If you encounter problems with GPIB communications with the LDC-3900 Modular
Laser Diode Controller, refer to your GPIB driver manual for the exact syntax of
the output terminator. See also, Appendix G.
<PROGRAM MESSAGE UNIT SEPARATOR>
A <PROGRAM MESSAGE UNIT SEPARATOR> is used to separate sequential
<PROGRAM MESSAGE UNIT> elements (commands) from one another within a
<PROGRAM MESSAGE>. The syntax for a <PROGRAM MESSAGE UNIT
SEPARATOR> is shown in Figure 3.3 on page 41.
Figure 3.3 <PROGRAM MESSAGE UNIT SEPARATOR> Syntax Diagram
NL
NL ^END
^END
<white space>
To Next Page
Loading...
Need help?
General
