These programs are only suitable for charging and discharging Lithium batteries with a
nominal voltage of 3.3V, 3.6V and 3.7V per cell. These batteries need to adopt different
charge technique that is termed a constant voltage (CV) and constant current (CC)
method. The charge current varies according to the battery capacity and performance.
The final voltage of charge process is also very important; it should be precisely
matched with the charade voltage of the battery. They are 4.2V for LiPo, 4.1V for Lilo,
and 3.6V for LiFe. The charge current and nominal voltage as for cell count set on the
charge program must always be correct for the battery to be charged.
When you are willing to alter the parameter value in the program, press start/enter key
to make it blink then change the value with Inc> or <Dec key. The value will be stored by
pressing start/enter key once.
12
To Next Page
Loading...
