Imax B8 - FAST Charging Lithium Battery; FAST Charge Process

The charging current is getting smaller as the process goes to the near end term of
Lithium battery charging. To finish charging process earlier, this program eliminate
certain term of CV process. The charging current will goes to 1/5 from the initial value to
end the process while the normal charging goes to 1/10 during CV term. The charging
capacity may be a bit smaller than normal charging but the process time will be reduced.
You can set up the charging current and the
voltage of the battery pack being charged. As you
press Start/Enter button the voltage confirmation
will be displayed. And then, if you confirm the
voltage and current, press Start/Enter button
again to start charging.
This shows the present state of FAST
charging. To stop charging arbitrary, press Batt
type/Stop key once.
DEC
INC
DEC
INC
Batt type
stop
Start
Enter
`>3seconds`
number
of
cells
elapsed
time
charge
current
supplied
capacity
Current
voltage of
battery
14