These programs are for charging or discharging NiMH(Nickel-Metal-Hydride) or
NiCd(Nickel-Cadmium) battery commonly used for R/C model applications. To alter the
value at the display, press Start/Enter key to make it blink then change the value using
Inc> or <Dec kep. The value will be stored by pressing Start/Enter key once.
To start the process, press Start/Enter button for more than 3 seconds.
This program simply charges the battery using
the current you set. In Aut mode,You need to
set the upper limit of charge current to avoid from
higher feeding current that may damage the
battery. Because some batteries of low
impedance and small capacity can lead to the
higher charge current by the processor at
automatic charge mode. But in Man mode, it
will charge the battery with the charge current
you set at the display. Each mode can be
switched by pressing Inc> and <Dec button
simultaneously when the current field is blinking.
The screen displays the current state of charging.
To stop the process, press Batt type/Stop key
once. The audible sound indicated you the end of
process.
DEC
INC
Batt type
stop
Start
Enter
`>3seconds`
elapsed
time
charge
current
battery
voltage
discharged
capacity
battery
type
18
To Next Page
Loading...
