you can set the upper limit of charge current to avoid from high current charging. This is
very useful when charging the low impedance and small capacity NiMH battery in
AUTO mode.
Capacity Limit The charging capacity always calculated by multiple of the charging
current and time. If the charging capacity exceeds the limit the process will be
terminated automatically when you set the maximum value.
Temperature Limit The temperature of the battery on charging will rise by its internal
chemical reaction. If you set the limit of temperature the process will be expired forcibly
when the limit has reached.
Processing Time Limit You can also restrain the maximum process time to prevent
from any possible defect.
Input Power Monitor To protect the car battery using as input power from being
damaged the voltage of it always monitored. If it drops below the lower limit the process
will be ended automatically.
Data Store/Load
For users convenience it can store maximum 10 data of different batteries. You can
establish the data contains program setting of the battery to charge or discharge
continually. These data can be called out at any time you need and the process can be
executed without program setting.
Cyclic charging/discharging
Perform 1 to 5 cycles of charge?discharge or discharge?charge continually for battery
refreshing and balancing.
PC based analysis using USB communication
For technical expert, B8 offers PC based program can analysis the characteristic of the
battery by USB port. It shows a graph of voltage, current, capacity and temperature
curves. It also shows the individual voltage of each cell in the Lithium battery pack.
*PC analysis software and USB Link wire are not included
Multi-use wires
Five kinds of wires are provided with the B8 charger.You can charge and discharge your
battery easily with these wires.
02
To Next Page
Loading...
