Never leave the charger unsupervised when it is connected to its power supply. If any
malfunction is observed immediately terminate the process and refer to the operation
manual.
Keep the unit away from dust, damp, rain, heat, direct sunshine and vibration. Do not
drop it.
The circuit of the unit is designed to be powered by a 11-18 DC only.
This unit and the battery to charge or discharge should be set up on a heat-resistant,
non inflammable and non-conductive surface. Never place them on a car seat, carpet or
similar. Keep all the inflammable volatile materials well away from operating area.
Cooling vent of charger can not be covered or closed in order to keep good ventilation.
Make sure to completely understand the feature of batteries to be charged or
discharged. If the program is set up incorrectly, the battery may be severely damaged.
Especially for Lithium battery, it may cause fire or explode if charged incorrectly or
overcharged.
Voltage level: 1.2V/cell
Voltage level: 3.6V/cell
Max charge voltage: 4.1V/cell
Allowable fast charge current: 1C or less
Min. discharge voltage cut off level: 2.5V/cell or higher
Voltage level: 3.7V/cell
Max charge voltage: 4.2V/cell
Allowable fast charge current: 1C or less
Discharge voltage cut off level: 3.0V/cell or higher
Allowable fast charge current: 1C~2C depends on the
performance of cellDischarge voltage cut off level:
0.85V/cell(NiCd), 1.0V/cell(NiMH)
Voltage level: 3.3V/cell
Max charge voltage: 3.6V/cell
Allowable fast charge current: 4C or less(e.g. A123M1)
Discharge voltage cut off level: 2.0V/cell or higher
Voltage level: 2.0V/cell
Max charge voltage: 2.46V/cell
Allowable fast charge current: 0.4C or less
Discharge voltage cut off level: 1.75V/cell or higher
04
To Next Page
Loading...
