This is for charging or discharging Lithium battery not to be used for the time being. The
program will determine to charge or discharge the battery to the certain voltage
depending on the voltage of the battery at its initial stage. They are different from the
type of the batter, 3.75V for Lilo, 3.85V for LiPo and 3.3V for LiFe per cell. If the voltage
of battery at its initial stage is over the voltage level to storage. The program will start to
discharge.
DEC
INC
DEC
INC
Batt type
stop
Start
Enter
`>3seconds`
number
of
cells
elapsed
time
charge
or
discharge
current
supplied
capacity
Current
voltage of
battery
You can set up the current and the voltage of the
battery pack to be charged. The current will be
used for charge or discharge the battery to reach
the storage level of voltage.
The screen shows the present situation during
charge process. To stop charging press Batt
type/Stop key once.
15
To Next Page
Loading...
