This is programmed for charging Pb(lead-acid) battery with nominal voltage from 2 to
36V. Pb batteries are totally different from NiCd or NiMH batteries. They can only
deliver relatively lower current compare to their capacity, and similar restrictions
definitely apply to charge. So the optimal charge current will be 1/10 of the capacity. Pb
batteries must not be charged rapidly. Always follow the instruction is supplied by the
manufacture of battery.
When you are willing to alter the parameter value in the program, press Start/Enter key
to make it blink then change the value with Inc> or <Dec key. The value will be stored by
pressing Start/Enter key once.
Set up the charge current on the left and the
nominal voltage of the battery on the right. The
charge current ranges from 0.1 to 7.0A and the
voltage should be matched with the battery being
charged.
Start the charge process by pressing Start/Enter
key for more than 3 seconds.
The screen displays the state of charging process.
To stop charging forcibly, press Batt type/Stop key
once. The audible sound indicates you at the end
of process.
DEC
INC
Batt type
stop
Start
Enter
`>3seconds`
DEC
INC
elapsed
time
charge
current
battery
voltage
charge
capacity
21
To Next Page
Loading...
