Need help?Do you have a question about the Implen P 300 and is the answer not in the manual?
General| Brand | Implen |
|---|---|
| Model | P 300 |
| Category | Measuring Instruments |
| Language | English |
Lists EU directives for compliance.
Details harmonized standards followed.
Guidelines for proper setup and operating conditions.
Step-by-step guide for using the submicroliter cell.
Introduces nucleic acid quantification and purity checks.
Steps to configure parameters for dsDNA, ssDNA, RNA.
Steps to configure parameters for oligonucleotides.
Steps to configure parameters for dye incorporation.
Method for quantifying proteins using absorbance at 280 nm.
Overview of Bradford, Biuret, BCA, Lowry assays.
Steps to configure parameters for protein UV measurement.
Steps to configure parameters for protein UV dye measurement.
Initial setup for the BCA assay.
Initial setup for the Bradford assay.
Initial setup for the Lowry assay.
Initial setup for the Biuret assay.
Principles and factors affecting OD600 readings.
Steps to configure parameters for bacterial growth monitoring.
Steps to configure parameters for single wavelength measurements.
Steps to configure parameters for concentration determination.
Steps to configure parameters for spectral scanning.
Configuring parameters for time-dependent measurements.
Configuring parameters for generating calibration curves.
Steps for performing calibration measurements.
Steps to configure parameters for multiple wavelength measurements.
Steps to configure parameters for absorbance ratio determination.
Organizing, protecting, and renaming saved methods.
Information on the lack of routine maintenance.
Guidance on component lifespan and replacement.
Detailed list of error messages and their resolutions.
Solutions for common operational problems.
To Next Page
