What to do if Implen Measuring Instruments shows 'Concentration too high. Dilute sample.'?
If the concentration of your sample is too high for submicroliter cell measurements using Lid 250 with the C40, dilute the sample manually. This will allow you to measure within the detection range of the instrument.
What to do if Implen NanoPhotometer N120 Measuring Instruments shows 'Concentration too high. Change to lid10/lid50/lid100/lid250.'?
If the concentration of the sample used is too high for submicroliter cell measurements with the utilized lid, change to the recommended lid. It is also recommended to use a new blank when changing the dilution lid.
Why does Implen NanoPhotometer N120 show an air bubble, lint residue or bad sample error?
The 'air bubble, lint residue, or bad sample' error appears when the air bubble recognition feature is on and detects an air bubble, lint residue, or a compromised sample, such as a turbid sample. To resolve this: * Check your sample. * Thoroughly clean the pedestal and mirror in the lid. * Carefully reapply the sample, using reverse pipetting to prevent air bubbles.
What to do if Implen Measuring Instruments says the battery is low?
If the device indicates that the battery is low, connect it to a power source.
What to do if Implen NanoPhotometer N120 says another control device is currently connected?
Please close the method on the control device.
What to do if Implen Measuring Instruments concentration is too high for the lid?
If the concentration of your sample is too high for submicroliter cell measurements with the current lid, it is recommended to switch to the lid specified by the device. Remember to run a new blank after changing the dilution lid.
What to do if Implen NanoPhotometer N120 concentration is too high and says 'Dilute sample'?
If the concentration of your sample is too high for submicroliter cell measurements using Lid 250 with the C40, dilute the sample manually. This will bring the concentration within the instrument's detection range.
What to do if Implen NanoPhotometer N120 Measuring Instruments battery is low?
If your Implen Measuring Instruments indicates a low battery, connect it to a power source immediately.
Why Implen NanoPhotometer N120 says another control device is currently connected?
If you see this message on a control device, it means another control device is already connected and has an open measurement session. To resolve this, close the method on the other control device.
How to fix air bubble, lint residue or bad sample error on Implen NanoPhotometer N120 Measuring Instruments?
If the air bubble recognition feature is active and detects an air bubble, lint residue, or a compromised sample (e.g., a turbid sample), inspect the sample. Clean the sample window on the pedestal and the mirror in the lid arm thoroughly. Reapply the sample carefully, using reverse pipetting to prevent air bubbles.
General| Light Source | Xenon flash lamp |
|---|---|
| Weight | 2.5 kg |
| Sample Volume | 0.3 - 2 µL |
| Display | Touchscreen |
| Data Output | USB, Ethernet |
| Detector | 2048 element CCD array |
| Path Lengths | 0.1 cm |
| Absorbance Accuracy | ± 0.003 (at 1.0 A) |
| Operating System | Embedded |
| Dimensions | 200 x 200 x 150 mm |
| Power Supply | 100 - 240 V |
| Optical Resolution | ≤ 3 nm |
| Photometric Accuracy | ± 0.003 (at 1.0 A) |
| Photometric Repeatability | ± 0.002 A |
To Next Page
