NanoPhotometer
®
N120/NP80/N60/N50/C40 User Manual Version 4.3.1
141
Update procedure:
1. Unzip the installation file to a USB flash drive into the root folder
2. Insert in the USB flash drive to the USB port of the NanoPhotometer
®
3. Select Assistance/Software Maintenance
4. Push on “Update” and wait until the NanoPhotometer
®
reboots
Note: Once you have updated the firmware of the NanoPhotometer
®
, please update the
client software (PC/Mac, tablet, smartphone).
CREATE LOG FILE
To create a log file insert a USB flash drive to the USB port of the NanoPhotometer
®
. Push
on “Create Log File”. The log (NPOS.log) file will be saved on the root folder of the USB
flash drive.
FACTORY RESET
There is an option to reset the instrument to factory settings. By selecting the reset button a
window will open that says “Reset the NanoPhotometer
®
?” Selecting the cancel button will
close the window without changing the settings and selecting reset will open a window that
will ask again ”Reset the NanoPhotometer
®
to factory settings? All data, stored methods and
settings will be lost.” If it is confirmed the factory settings will be restored.
Note: All stored methods, settings and data on the NanoPhotometer
®
will be deleted if the
reset option is executed.
CREATE BACKUP
Option to create backup file to recover data and settings of the NanoPhotometer
®
at a later
date. To create a backup file insert a USB flash drive to the USB port of the
NanoPhotometer
®
. Push on “Create Backup”. The backup (NPOS.bak) file will be saved into
the root folder of the USB flash drive.
Recovery of the NanoPhotometer
®
is only possible via the Implen support (remote access).
In the case a NanoPhotometer
®
recovery is necessary please get in touch with the Implen
support team (support@implen.de).
To Next Page
Loading...
Need help?
General
