To Next Page

To Previous Page

NanoPhotometer

N120/NP80/N60/N50/C40 User Manual Version 4.3.1

CUVETTE MEASUREMENT BASICS (C40/NP80)

The NanoPhotometer

(NP80 and C40 only) is compatible with standard cuvettes having an

8.5 mm center height. The light path is indicated with a red status LED arrow for the NP80

model and with two white arrows for the C40 model.

Note: For the NP80 the cuvette compartment needs to be activated by the “Change to

Cuvette” button in the parameter area. Once the cuvette option is activated the sample

compartment door will be opened automatically and a red arrow above the cuvette

compartment will appear. The arrow indicates the light path.

1. Select a method depending on your sample and set the parameters for the

measurement.

2. Open the automatic cuvette cover by pushing the “Change to Cuvette” button below the

parameter area (NP80 only).

3. Add a blank solution to a cuvette and ensure that the filling volume is sufficient to allow

light path to pass through the solution.

4. Insert cuvette into the cell holder.

5. Initiate a blank measurement with the blank button. Upon completion of measurement

remove the cuvette.

6. Add sample to a cuvette and ensure that the sample volume is sufficient to allow light to

pass through the sample.

7. It is possible to enter a sample name for each sample in the input window “enter sample

name”.

Note: Allowed characters are: A…Z a…z 0…9 , . - ( ) @ ! = _ ~ ; [ ] { } ‘

Note: Blank character is not allowed.

8. Initiate a sample measurement with the sample button. Upon completion of

measurement remove the cuvette.

9. Apply further samples.

Implen NanoPhotometer N120 User Manual

Questions and Answers: