Inateck BCST-10 - Code 39 Settings

58
3.6 Code 39
3.6.1 Enable/Disable Code 39
Decide whether or not to enable Code 39, The BCST-10 Scanner
defaults enable Code 39.
3.6.2 START/STOP Transmission
Decide whether or not to include the start/stop characters in the data
being transmitted.
For example: Do Not Transmit Code 39 Start/Stop Characters.
1. Read the "Enter Setup" barcode;
2. Read the "Enable Code 39" barcode; (If Code 39is disabled, it
is need to set); 3. Read the "Do Not Transmit Code 39
Start/Stop Characters" barcode;
4. Read the "Exit with Save" barcode.
Enter Setup
Exit with Save
Exit without Save
（*）Enable Code 39
Disable Code 39
*Transmit Code 39 Start/Stop Characters
*Do Not Transmit Code 39 Start/Stop Characters