72
Copyright © 2004-2012 by InfiNet Wireless
• Mode – main working parameters currently used by the interface for its
operation
• Packets Rx/Tx – the number of received/transmitted packets via the
interface
• Errors Rx/Tx – the number of errors on the interface when
receiving/transmitting
• Load (kbps) Rx/Tx – the data load of the interface in kilobits per second
• Load (pps) Rx/Tx – the data load of the interface in packets per second.
The “Wireless Links Statistics” section displays all neighboring devices which the
interface (RF or Pseudo-RF) of the given node is connected to. The following
radio link parameters are displayed:
• Link Quality – indicates the quality of the link to a neighboring device:
green – the link has acceptable characteristics, yellow – the link has
significant problems, red – the link has unsatisfactory characteristics.
• Neighbor – the neighbor’s name
• MAC Address – the neighbor’s MAC address
• Node ID – the sequential number of the neighboring node
• Distance – the distance of the link
• Transmit Power (dBm) Rx/Tx – transmit power values for remote/local
sides of the link in dBm
• Control Level (dB) Rx/Tx – signal levels for receiving/transmitting (in dB)
measured relative to the minimum possible bitrate
• Current Level (dB) Rx/Tx - signal levels for receiving/transmitting (in dB)
measured relative to the Rx/Tx bitrates that are currently used for the
link
• Bitrate Rx/Tx – the bitrates for receiving/transmitting that are currently
used for the link
• Retries (%) Rx/Tx – measured percentage of the resent packets on the
link for receiving/transmitting
• Errors (%) Rx/Tx – measured percentage of the errors on the link for
receiving/transmitting
• Load (kbps) Rx/Tx – the data load of the link in kilobits per second
• Load (pps) Rx/Tx – the data load of the link in packets per second
The
“Refresh” button updates the statistics.
The “Auto Refresh”
check-box enables automatic statistics update. The update
frequency (in seconds) can be set by the “Auto Refresh Time” parameter. The
minimal possible value, “0” seconds, makes update process instant.
The “Show System Log” button shows the “System Log” section.
To Next Page
Loading...
Need help?
General
