10
Displaying an image
Touch the Power button on the keypad or the remote.
The Power button blinks green and the fans st
art to run. When the lamp
turns on, the start up screen will display and the Power button will become
solid green. It can take a minute for the image to achieve full brightness.
No start up screen? Get h
e
lp on page 15.
Slide the lens cover to the side, if it is covering the lens.
Turn on your computer or video device.
The image should appear on the pro
j
ection screen. If it doesn’t, press the
Source button on the projector’s keypad or remote.
If you are using a VGA cable to connect your computer
t
o the projector (instead
of DisplayLink):
If using a laptop, make sure its external video port is active.
Many laptops do not automatically turn on their external video port when a
projector is connected. Usually a key combination like Fn + F8 or CRT/LCD
key turns the external display on and off. Locate a function key labeled
CRT/LCD or a function key with a monitor symbol. Press Fn and the
labeled function key simultaneously. Refer to your laptop’s documentation
for more information about your laptop’s key combination or go to the
InFocus website at: http://www.infocus.com/Support/LaptopActivation.aspx.
No laptop image? Tr
y pressing the Auto Image button on the keypad.
Is your laptop connected to the projector's DisplayLink connector? See
the
InFocus DisplayLink Software User's Guide (available on the InFocus
website at www.infocus.com/displaylink) for troubleshooting information.
To Next Page
Loading...
