32
Status and Service menu
Source Info: Displays current source settings (read-only).
Projector Info: Disp
lays current projector settings (read-only).
Reset Lamp Hours: Resets the
lamp hours used counter in the Projector Info
menu to zero. Do this only after changing the lamp.
Factory Reset: Restores all settings to
their default.
Service Code: Only
used by authorized service personnel.
Help
Press Help (on the keypad or remote) at any time to get interactive help for
solving common, picture, sound, and cabling problems.
NOTE: The projector can be re-programmed to display a custom (non-inter-
active) screen when Help is pressed. To do this: Create your custom screen
on a computer and display it on the projector, then use the Take Snapshot
command in the Setup menu. When you see the Snapshot Successful mes-
sage, hold down the Help button until the message is removed.
To revert a customized Help screen back to the InFocus default Help screen,
a Factory Reset will be needed.
To Next Page
Loading...
