11
Adjusting the image
If necessary, adjust the height of the projector by pressing the elevator foot
release button to extend the foot.
Rotate the elevator feet for granular adjustment of the pr
ojector’s height.
Avoid
placing your hands near the hot exhaust vent at the side of the
projector.
Avoid placing your hands near the hot e
x
haust vent at the side of the
projector.
Position the projector to the desi
red distance from the screen at a 90 degree
angle to the screen. See page 6 for a table listing to screen sizes and
distances.
Adjust the zoom or focus.
If the image is not square, first make sure that the p
rojector is perpendicular
to the screen. To reduce the size of the top edge of the image, press the top
Keystone button. To reduce the size of the bottom edge of the image, press
the bottom Keystone button.
If the left or right side of the screen is larger
or
smaller than the other, you
can turn the projector to the left or to the right a few degrees to square the
image. See page 6 for details.
Adjust the Contrast or Brightness in the Basic
Picture menu. See page 27 for
help with these menu adjustments.
To Next Page
Loading...
