InFocus LP130 User Manual

31
Replacing the Batteries in the Remote Control
The life of the batteries depends on how often and how long you
use the remote. Symptoms of low battery charge include erratic
responses when using the remote and a reduced range of opera-
tion.
Follow these steps to replace the batteries:
1
Turn the remote face down in your hand.
2
Push the tab on the battery door toward the top of the remote
and lift the door off.
3
Remove the old batteries and dispose of them in an environ-
mentally proper manner.
4
Install two new AAA alkaline batteries. Make sure you install
each in the correct direction.
5
Insert the hooks on the battery door into the remote and press
the tab to re-install the door.
Using the Security Lock
NOTE: The lamp cannot be
removed while the security lock is
attached.
The projector has a security connector for use with a PC Guardian
Cable Lock System (Figure 25). See “Optional Accessories” on
page 39 for ordering information. Refer to the information that
came with the lock for instructions on how to use it to secure the
projector.
F
IGURE
25
Installing the security lock

InFocus LP130 Specifications

Projection Distances and Image Sizes

projection distance 5 feet	1.52 m
min image size at 5 feet	0.90 m
max image size at 5 feet	1.10 m
projection distance 8 feet	2.44 m
min image size at 8 feet	1.44 m
max image size at 8 feet	1.76 m
projection distance 12 feet	3.66 m
min image size at 12 feet	2.16 m
max image size at 12 feet	2.63 m
projection distance 16 feet	4.88 m
min image size at 16 feet	2.88 m
max image size at 16 feet	3.51 m
projection distance 20 feet	6.10 m
min image size at 20 feet	3.60 m
max image size at 20 feet	4.39 m
projection distance 30 feet	9.14 m
min image size at 30 feet	5.39 m
max image size at 30 feet	6.58 m

Display and Image

display technology	DLP from Texas Instruments
native resolution	1024 x 768
brightness	1100 ANSI lumens
contrast ratio	400:1 full on full off
aspect ratio	4:3
displayable color palette	16.7 million colors

Lens and Projection

projection lens zoom ratio	1.22:1
projection ratio wide	0.72:1
projection ratio narrow	0.59:1
projection offset	111.3% typical
digital keystone correction	+/- 20˚

Power and Consumption

light source	120 Watt UHP+
lamp life	2000 hours
power supply	100-120V, 200-240V at 50Hz-60 Hz
power consumption	150 Watts

Weight and Dimensions

dimensions	6.68" x 8.63" x 2.0" (170mm x 219mm x 51mm)
weight	3 lbs (1.36 kg)
operational noise	37dB