Operation22
Entering the password recall procedure
1. Press and hold AUTO on the projector or
remote control for 3 seconds. The projector
will display a coded number on the screen.
2. Write down the number and turn off your
projector.
3. Seek help from the local service center to
decode the number. You may be required to
provide proof of purchase documentation to
verify that you are an authorized user of the
projector.
Changing the password
1. Open the OSD menu and go to the SYSTEM SETUP: Advanced > Security
Settings > Change password menu.
2. Press MODE/ENTER. The message 'INPUT CURRENT PASSWORD'
displays.
3. Enter the old password.
• If the password is correct, another message 'INPUT NEW PASSWORD'
displays.
• If the password is incorrect, the password error message displays lasting
for three seconds, and the message 'INPUT CURRENT PASSWORD'
displays for your retry. You can press MENU/EXIT to cancel the change
or try another password.
4. Enter a new password.
The digits being input will display as asterisks on-screen. Write your selected password down
here in this reference guide in advance or right after the password is entered so that it is
available to you should you ever forget it.
Password: __ __ __ __ __ __
Keep this reference guide in a safe place.
5. Confirm the new password by re-entering the new password.
6. You have successfully assigned a new password to the projector. Remember
to enter the new password next time the projector is started.
7. To leave the OSD menu, press MENU/EXIT.
Disabling the password function
To disable password protection, go back to the SYSTEM SETUP: Advanced >
Security Settings > Power on lock menu after opening the OSD menu system.
Select Off by pressing / . The message 'INPUT PASSWORD' displays. Enter
the current password.
• If the password is correct, the OSD menu returns to the Security
Settings page with 'Off' shown in the row of Power on lock. You will not
have to enter the password next time you turn on the projector.
• If the password is incorrect, the password error message displays lasting
for three seconds, and the message 'INPUT PASSWORD' displays for
Please write down the recall code,
and contact InFocus
Customer Center.
Recall code:
0 2 1 2
RECALL PASSWORD
Exit
MENU
To Next Page
Loading...
Need help?
General
Weight and Dimensions
