InFocus X17 User Manual

Operation32
9. Press MENU/EXIT to exit and save the settings.
Saturation is the amount of that color in a video picture. Lower settings produce less
saturated colors; a setting of “0” removes that color from the image entirely. If the saturation
is too high, that color will be overpowering and unrealistic.
Setting the presentation timer
The presentation timer can indicate the presentation time on the screen to help you
achieve better time management when giving presentations. Follow these steps to
utilize this function:
1. Go to the SYSTEM SETUP: Basic >
Presentation Timer menu and press
MODE/ENTER to display the Presentation
Timer page.
2. Highlight Timer Period and decide the time
period by pressing / . The length of time
can be set from 1 to 5 minutes in 1-minute
increments and 5 to 240 minutes in 5-minute increments.
If the timer is already on, the timer will restart whenever the Timer Period is reset.
3. Press to highlight Timer Display and choose if you want the timer to show
up on the screen by press
ing / .
4. Press to highlight Timer Position and set the timer position by pressing
/
.
Top-Left Bottom-Left Top-Right Bottom-Right
5. Press to highlight Timer Counting Direction and select your desired
counting direction by pressing / .
6. Press to highlight Sound Reminder and decide if you want to activate
sound reminder by pressing / . If you select On, a double beep sound will
be heard at the last 30 seconds of counting down/up, and a triple beep sound
will be produced when the timer is up.
7. To activate the presentation timer, press and press / to highlight On
and press MODE/ENTER.
8. A confirmation message displays. Highlight Yes and press MODE/ENTER to
confirm. You will see the message “Timer is On” displaying on the screen.
The timer starts counting at the time the timer is on.
Selection Description
Always Displays the timer on screen throughout the presentation time.
1 min/2 min/3 min Displays the timer on screen in the last 1/2/3 minute(s).
Never Hides the timer throughout the presentation time.
Selection Description
Count Up Increases from 0 to the preset time.
Count Down Decreases from the preset time to 0.
Presentation Timer
Timer Display
Timer Position
Timer Counting Direction
Sound Reminder
Always
Top-Left
Count Down
Off
On Off
MENU Back
Timer Period
15

InFocus X17 Specifications

General

Matrix size	0.55 \
Projection distance	1.49/6 m
Vertical scan range	56 - 85 Hz
Horizontal scan range	31.35 - 68.7 kHz
Projection technology	DLP
Contrast ratio (typical)	2000:1
Screen size compatibility	0.69 - 6.4 \
Projector native resolution	XGA (1024x768)
Keystone correction, vertical	-30/30 °
Aspect ratio	4:3, 5:4, 16:9
RS-232 ports	1
Dimensions (WxDxH)	223.5 x 263.9 x 111.8 mm
Power requirements	100 - 240 V, 50 - 60 Hz
Throw ratio	1.9 - 2.1:1
Lamp power	140 W
Light source type	Lamp
Service life of light source (economic mode)	4000 h
Analog signal format system	NTSC, PAL, SECAM
RMS rated power	5 W
Serial interface type	RS-232
Noise level	29 dB
Power consumption (typical)	285 W
Operating temperature (T-T)	5 - 35 °C
Placement	Ceiling

Weight and Dimensions

Weight	2400 g