EonStor / EonStor DS S12/S16/S24 Series
2. Unlock the driv
e tray bezel (indicated by the blue arrow) by using a small
the bezel lock from lock to the un-lock position. flat-blade screwdriver to set
3. Open the drive tray. Press the button. The spring handle will pop out.
4. Remove the drive tray. Pull the tray one inch away from the enclosure. Wait for
at least 30 seconds for the disk drive to spin down, and then gently withdraw the
drive tray from the chassis.
5. Remove four retention screws (two on each side). The screws secure the hard
drive to the drive tray (indicated by the blue arrows).
Hard drive screw locations without mux board
Hard drive screw locations with mux board
164
To Next Page
Loading...
