EonStor / EonStor DS S12/S16/S24 Series
6. Replac
e the drive. After swapping the drive, fasten the retention screws back.
Without MUX With MUX
y back into the enclosure. Install the drive tray with the
front bezel open. When fully inserted, close the front bezel.
7. Insert the drive tra
8. Lock the drive tray. Turn the bezel lock to the vertical orientation (locked
position) using a flat blade screwdriver. Do not push the bezel lock while turning
it, otherwise the spring handle will pop out again.
NOTE
Never leave the bezel lock unlocked – the RAID controller might consider it as a sign
of faulty drive.
9. Check f poor drive error. Make sure that there is no more error re rted.
165
To Next Page
Loading...
