900021971 R11 000 06/0818
Copyright© 2018
Ingenico
All rights reserved
4_3
Installing the Terminal
4_3_1 Installing SAM (Secure access
module, optional)
CAUTION
Before starting, switch off the terminal by disconnecting the
cable.
Perform the following operations:
Open the trapdoor
Unclip the trapdoor by pushing down on the clip with
your finger as shown on the figure hereafter.
Then lift the trapdoor to remove it.
Insert the SAM Card into the slot marked , or
3
.
Take care to ensure that the SAM Card is inserted in the
correct manner. The cut corner must be positioned as
indicated on the figure below.
Cut corner
To Next Page
Loading...
