900021971 R11 000 06/0818
Copyright© 2018
Ingenico
All rights reserved
Close down side trapdoor
To close the trapdoor, put the trapdoor onto the bottom
casing, and then push it upward to clip it.
CAUTION
Do not use any tools when installing or removing the SAM
Card.
4_3_2
Installing MicroSD Card
(optional)
CAUTION
Before starting, switch off the terminal by disconnecting the
cable.
Perform the following operations:
Open the trapdoor
Unclip the trapdoor by pushing down on the clip with
your finger as shown on the figure hereafter.
Then lift the trapdoor to remove it.
Slide the metallic part on the left and lift it up to open the
card holder, marked (SD)
Insert completely the MicroSD Card into the slot as indicated
on the figure.
The contacts must be positioned down side.
To Next Page
Loading...
