InHand InSwitch ISM-P Series - Basic Configuration; Global Configuration Mode (Management Interface)

WEB Configuration Manual
- 9 -
Chapter 3 Basic Configuration
3.1 System
If you click
Basic Setting -> System
in the navigation bar, the page appears as shown as below
：
The system message will be displayed in the dialog box.
The default name of the device is “Switch”. You can enter the new hostname in the text box and
then click “Set” in the bottom control bar.
3.2 Global Configuration Mode (Management Interface)
If you click
Basic Setting -> Global Network Config
in the navigation bar, the page appears as
shown as below: