InHand InSwitch ISM-P Series - LLDP Configuration; LLDP Basic Configuration

WEB Configuration Manual
- 70 -
11.4 LLDP Configuration
11.4.1 LLDP Basic Configuration
Click
Diagnostics -> LLDP -> Configuration
at navigation bar in order, and then enter the
basic configuration page of LLDP protocol as following
：
You can enable or disable the LLDP protocol. You cannot configure the LLDP protocol of the port
when LLDP is disabled.
HoldTime
refers to the ttl value for transmitting the LLDP message. The default value is 120s.
Reinit refers to the transmission delay of LLDP. The default value is 2s.
11.4.2 LLDP Interface
Click
Diagnostics -> LLDP -> LLDP Interface
at navigation bar in order, and then enter the LLDP
port configuration page as following:
LLDP port configuration can enable or disable the port transmitting LLDP packets, the default value
was disable both of receive and send LLDP packet. The default of MED-TLV is enabled.
11.4.3 Topology Discovery