InHand InSwitch ISM-P Series - Link Backup Protocol Port Configuration

WEB Configuration Manual
- 58 -
Click
Modify
on the right of the entry and configure the preemption mode and the preemption delay
mode of the link backup group.
The page lists current configured link backup group, including the preemption mode and the
preemption delay mode. Click
Create
to create a new link backup group.
Note
：
1. There are supported 8 group numbers of link backup group in this system.
2. The preemption mode of the link backup group decides the policy of the primary
port and the backup port selecting forwarding packets.
10.2.2 Link Backup Protocol Port Configuration
Click
Redundancy -> Backuplink -> Port Configuration
at navigation bar in order, and then enter
the backup link protocol port configuration page as following:
The page lists the member port has joined the backup link group, port attribute of the member port,
MMU attribute, load balance vlan. MMU sender can transmit the message to MMU receiver to
make the receiver quickly update the mac address table.