You can configure the MST Global Revision Level in this page.
Click
Set
to save configuration.
10.3.2.2 MST Instance
Click
Redundancy -> Spanning Tree -> MSTP
at navigation bar in order, and then click the
MST
Instance
to enter the configuration page as following:
This page shows the VLAN Mapping, priority and etc. of every instance.
Click
Reload
at the bottom control bar, refresh the MST Instance information.
Click
Modify
on the right of the table, configure the instance.
On this page, the path cost and priority can be configured. And click
Set
at the bottom control bar to
save the configuration.
To Next Page
Loading...