InHand InSwitch ISM-P Series - EAPS (ether-ring) Configuration

WEB Configuration Manual
- 62 -
This page shows the configuration of EAPS ring (ether-ring), including ring ID, node type, ring
description, CONTROL VLAN, status, Hello Time, Fail Time, Pre Forward Time and primary and
secondary port on the ring.
Click
Modify
on the right, change the time, primary and secondary port configuration on the EAPS
(ether-ring).
Click
Create
at the bottom control bar, create new EAPS (ether-ring).
Note:
1. The EAPS ring (ether-ring) number the system supported is 32.
2. After the EAPS ring (ether-ring) configured, the ring ID, node type and CONTROL VLAN cannot
be changed. If they needed to be changed, please delete the EAPS (ether-ring) and create new.
Click
Create
at the bottom control bar on the EAPS (ether-ring) page, or click
Modify
on the right,
enter the EAPS ring (ether-ring) configuration page:
In the drop-down list on the right of primary and secondary port, port of the ring can be chosen, or
“None” can be chosen.
Note:
If configure the existed EAPS ring (ether-ring), the ring ID, node type and CONTROL VLAN cannot
be changed.