Programming the SmartLink-GP 11
Programming manual
Note: To change the Web address of the page and reconnection
interval, select Settings, Application data,
Miscellaneous .
3.3.2 Setting up the computer serial output
Using the Settings, Application data, Serial Ports menus, check that the
selected settings match the serial cable you intend using for the computer to
SmartLink-GP connection.
3.3.3 Configuring a new system
1. Create a new solution (select File, New), or open a solution previously
used for a similar system (select File, Open), and save it in the name of
the new customer with the new account code.
2. Customize the parameter settings.
3. Save (select File, Save) and if necessary, print the details (menu File,
Print).
4. Connect the computer to the RS232 serial port of the device.
5. Download the 'solution' (configuration) to the device, select Program,
Download): all six LEDs will blink during this phase.
Note: If an error occurs during the downloading phase, you must
repeat the operation. The new data will overwrite the
previous configuration.
3.3.4 Programming an installed device
1. Connect the computer to the RS232 serial port of the device.
2. Create a new solution (select File, New), or open the current solution
(configuration) of the system (select File, Open).
3. To load the current parameters, select Program, Upload: all six LEDs
will blink during this phase.
4. Customize the parameter settings.
5. Save (select File, Save) and if necessary, print the details (menu File,
Print).
Download the 'solution' (configuration) to the device, select Program,
Download: all six LEDs will blink during this phase.
Note: If an error occurs during the downloading phase, you will
have to repeat the operation. The new data will overwrite
the previous configuration.
To Next Page
Loading...