INIM Electronics SmartLink-G - Programming Event Generated Actions

34 Programming the SmartLink-GP
Programming manual
3.10 Programming event generated actions
Figure 8 - Events table
The events are the core of the system and allow SmartLink-GP to manage
external conditions (e.g. input signals) and internal conditions (e.g. low
battery). The events can generate the following actions:
Enable SMS
without user
code - Out
If selected, SmartLink-GP will
accept SMS text commands
(to activate/deactivate one or
more IN&OUT outputs) from
the number concerned
without User code entry. The
action/s will be as per the
setup in the Inputs/
Outputs window. See
paragraph 3.12.3 Change
user code and paragraph
3.5.4 Setting up Caller ID
codes.
For example, to allow
the central station
operator to bar
entrance to the
premises.
Enable SMS
without user
code - Buzzer
If selected, SmartLink-GP will
accept SMS text commands
— to activate the buzzer —
from the number concerned
without User code entry. See
paragraph 3.12.6 Activating
the on-board buzzer and
paragraph 3.5.4 Setting up
Caller ID codes.
For example, to allow
the central station
operator to activate the
buzzer and warn
people on the
SmartLink-GP protected
premises of nuisance
situations.
Enable SMS
without user
code - Status
If selected, SmartLink-GP will
accept SMS text status
enquiries from the number
concerned without User code
entry. See paragraph 3.12.7
SmartLink-GP status enquiry.
For example, to allow
the service technician
to check the SIM credit
balance and battery
status.
Parameter Description Example