INIM Electronics SmartLink-G - Remote Control of Smartlink-GP Via DTMF Tones

52 Programming the SmartLink-GP
Programming manual
Note: For security reasons, the respective SMS message will be
deleted automatically from the SIM card after acquisition.
Refer to paragraph 3.6 Setting up the SmartLink
parameters for the parameter descriptions.
3.13.7 Write/Change telephone number
SL NUM<TelephoneNum> <number>
Example
“SL NUM2 063333133”
Note: Refer to paragraph 3.5.1 Settting up outgoing call numbers
for the parameter descriptions.
3.14 Remote control of SmartLink-GP via
DTMF tones
The SmartLink-GP will accept DTMF tone commands from remote phones,
during incoming calls (user to SmartLink-GP) and outgoing calls (SmartLink-
GP to user) on the PSTN or GSM network for:
• Arm/Disarm Intrusion Control Panel
• Input status enquiry
Tonecheck Monitors line tone
RemoveDigits Number of digits
AddAreaCode Prefix to add
InstallerCode Installer’s code
EnablePSTNanswerphone Enables PSTN answerphone
EnableGSManswerphone Enables GSM answerphone
DoubleCall Enables Double Call answer
NumberofRings Number of Rings
Parameter Description
TelephoneNum Location in Phonebook, 1 to 10
number Number changed
Parameter Description