Programming the SmartLink-GP 9
Programming manual
Note: You should select the suggested folder.
6. Select 'Continue': file installation initializes, the progress bar will
indicate completion.
Note: Always complete installation, do not select Cancel during
the installation phase.
7. Once installation has been completed, the SmartLeague icon will appear
on your desktop (if requested by the user) and in the program
list:
3.2.2 Check for the availability of a new version
of the SmartLeague software.
8. Connect with us at www.inim.biz to find out about SmartLeague
software upgrades.
9. View the differences between the new version and the installed version.
10. Work carefully through the upgrade instructions.
3.2.3 Check for the availability of a new version
of the firmware.
11. Connect with us at www.inim.biz to find out about SmartLink-GP
firmware upgrades.
12. Work carefully through the download and installation instructions. All
upgrades come with the revised version of the manual.
3.3 SmartLeague software
SmartLeague is the SmartLink-GP configuring software. The program is
designed to run on your service computer and will allow you to program
most of the SmartLink-GP parameters without actually being connected to
the system.
Your service computer must be connected to the mounted powered-up
SmartLink-GP during the parameter downloading phase.
The connection cable must be long enough to reach the mounted device
without difficulty. Refer to the Installation Manual - paragraph 7.13
Connecting the RS232 PC serial link.
The parameter settings can be saved to the SmartLeague database and used
for service purposes or as a 'standard configuration' for other SmartLink-GP
devices.
During service sessions, you will be able to view and change the SmartLink-
GP parameter settings.
To Next Page
Loading...