8 Programming the SmartLink-GP
Programming manual
Chapter 3
Programming the SmartLink-GP
3.1 Introduction
The SmartLink-GP can be programmed to manage:
• Intrusion control
• SMS dialler
• Contact ID Dialler
• Remote appliance control
• Voice dialler (optional feature)
Note: If the SmartLink-GP is used as a reserve line generator, no
programming is required.
SmartLink-GP programming requirements:
• a portable computer for parameter downloading to the powered-up wall-
mounted device
• RS232 link cable
• SmartLeague software
3.2 Installing the SmartLeague software
3.2.1 Installing SmartLeague from the CD
If included in your purchase order, you will have the SmartLeague
Installation CD containing the software for the respective SmartLink-GP
firmware. Check the software version, refer to Help, About SmartLeague.
New versions of the SmartLeague software can be downloaded from the INIM
electronics Web address at www.inim.biz.
After installing the SmartLeague software, contact the Web address to find
out about new versions. Internet connection required.
Installation instructions
1. Insert the Installation CD into your service computer.
2. Select 'Computer Resources' on your desktop.
3. Find the CD unit, double click on the icon: the CD contents will be
displayed.
4. Double click on
Setup.exe: the Welcome to the installation
program window appears.
5. Select 'Continue': the Folder selection window appears.
To Next Page
Loading...