INIM Electronics SmartLink-G - Programming the Device Via SMS Messages

Programming the SmartLink-GP 47
Programming manual
Example of SmartLink-GP answer:
INIM SmartLink-GP Rev. x.xx: IN x-x-x-x-x ; PSTN aa; GSM aa; PWR aa; SYS
aa; <GSM operator> REMAINING CREDIT ee.ee Euro
Note: Several commands can be sent in the same SMS message,
therefore, you can send multi-command messages similar
to the following:“OUT1 ON BEEP 5 OUT2 ON STATUS OUT4
OFF SYSTEM ON” (for a maximum of 70 characters).
3.13 Programming the device via SMS
messages
The installer can carry out minor operations using the SIM card, such as:
• program an output
• program an event
• insert/change an SMS message
Parameter Description Note
Rev. x.xx Installed firmware version
IN x-x-x-x-x The input slot (1,2,3,4,5) will
show the respective status
number (1=status 1, 2=status
2, etc.).
Example: IN 2 1 1 4
indicates Input
1=status 2, input
2=status 1, etc.
PSTN aa Land line (PSTN) status
OK=line working, KO= line
down or trouble
GSM aa GSM network status OK=line
working, KO= line down or
trouble
PWR aa Battery status OK=battery
charged, KO= battery down
SYS aa (for
GP models
only, if the
Intrusion
Control
facility is
active)
Panel status. ON=armed,
OFF=disarmed
<GSM
operator>
REMAINING
CREDIT ee.ee
Euro
Credit enquiry reply from GSM
provider