INIM Electronics SmartLink-G - Setting up the Smartlink Parameters

18 Programming the SmartLink-GP
Programming manual
3.6 Setting up the SmartLink parameters
This table contains the general parameters of the SmartLink-GP.
Group
Parameter Description Note
Intrusion control parameters
Enable
intrusion
protection
parameters
If selected,
the SmartLink-GP will
operate as an intrusion
control panel. The inputs and
outputs and associated
events will be used for
intrusion control
management.
Delay
(input/output)
If the SmartLink-GP intrusion
control panel is disarmed,
the is the interval between
the moment of arming and
the instant the device detects
alarm status on an input.
If the intrusion control panel
is armed, it is the time the
user has to disarm the
SmartLink-GP after violating
a delayed input. If the user
does not disarm the intrusion
control panel before the
delay ends
the SmartLink-GP will
generate an alarm event.
See paragraph 3.7
Programming the
Inputs and Outputs —
IN&OUT, section
Inputs, Parameter
Type.
PSTN (land line) parameters
Tone check If selected, the device will
check the line for the dialing
tone before dialing.
Pulse dialing If selected, the device will
use pulse dialing, otherwise
it will use DTMF dialing.