Programming the SmartLink-GP 17
Programming manual
3.5.4 Setting up Caller ID codes
Figure 4 - Codes table
The SmartLeague application uses the installer, user and customer ID codes
for SMS or DTMF caller identification (Caller ID) and for SmartLink-GP
identification during Contact ID report transmissions to central stations.
Parameter Description Note
Installer code This is the access code
that SmartLeague uses
during communications
with the SmartLink-GP.
User code This is the access code
the user must enter in
SMS text message or
DTMF commands to the
SmartLink-GP.
See paragraph 3.12
Remote control of the
SmartLink-GP via SMS text
messages and paragraph
3.14 Remote control of
SmartLink-GP via DTMF
tones.
Customer
code
This is the code which
identifies the SmartLink-
GP during Contact ID
report transmissions to
central stations.
To Next Page
Loading...