Programming the SmartLink-GP 19
Programming manual
Trouble warning parameters
Enable 'PSTN
(land line)
down' warning
If selected, it will enable the
Land line down event and
visual signaling on the
trouble LED.
Enable 'No
GSM Service'
warning
If selected, it will enable the
No GSM Service event and
visual signaling on the
trouble LED.
Answerphone parameters
Enable land
line (PSTN)
answerphone
If selected, it will enable
remote control of the device
via DTMF tones on the land
line (PSTN).
If SmartLink-GP is
connected to a fax
machine or modem,
you must also enable
the Double call
option.
Enable GSM
answerphone
If selected, it will enable
remote control of the device
via DTMF tones on the GSM
network.
Enable Double
Call
Useful if the SmartLink-GP is
connected to a fax machine
or modem that will answer
after a set Number of
rings.
To stop a fax machine or
modem from answering a
DTMF maintenance call, first
enable the Double call option
then call the panel and hang
up (the call rings must be
less than the set Number of
rings), make a second call
within 60 seconds of hanging
up. The SmartLink-GP will
pick up the call on the first
ring of the second call and
will be ready to accept DTMF
commands.
Only if Enable PSTN
answerphone option
has been selected.
Program the fax
machine or modem to
answer after the set
Number of rings.
Number of
rings
The number of rings which
must be detected before
answering an incoming call.
Group
Parameter Description Note
To Next Page
Loading...