Programming the SmartLink-GP 23
Programming manual
Other parameters
Simplified
management
of bistable
outputs
the SmartLink-GP will restore
an event associated output
automatically (restore to
initial status ON or OFF)
when the toggle event clears.
This option applies to
bistable outputs activated by
the following events:
1. Low battery
2. PSTN line down
3. No GSM Service
4. Emergency calls only
5. Arm
6. Ring begin
If this option is
enabled, it will not be
necessary to program
restoral of outputs
associated with the
respective restoral
events (e.g. Restore
low battery, output
2=OFF)
Disable
automatic
credit-residue
notification
If selected, the device will
not make periodic SIM-
credit-residue enquiries to
the service provider.
SIM-credit residue
enquiries can be made
via the STATUS
message and using the
methods the service
provider consents to.
Status enquiry
answer
heading
Customized heading for the
status enquiry answer (see
paragraph 3.12.7 SmartLink-
GP status enquiry).
Max. 12 characters.
Volume
Input Volume Increases or decreases the
volume of the speaker —
utilized by the telephone
connected to SmartLink.
Changes to these
parameters may
jeopardize the
functionality of the
other features of the
device (Contact ID,
DTMF menu).
If these features are
used, and you wish to
change the volume,
you must carry out
functionality tests.
Output
Volume
Increases or decreases the
volume of the microphone —
utilized by the remote user.
Group
Parameter Description Note
To Next Page
Loading...