60 Default settings of the Smartlink-GP
Programming manual
Appendix C
Default settings of the Smartlink-GP
SmartLink-GP default settings:
• Credit limit: € 5;
• Status message header: “INIM S_LINK”;
• All the IN&OUT terminals are bistabile, normally- open outputs.
• All events will be saved to the Events log.
The following events generate output actions:
Enabled Parameters:
• Enable PSTN line-down warning;
• Enable No GSM Service warning;
• Simplified management of bistable outputs.
Codes
• Installer code 0000
• User code 0001
• Customer code 0001
Restoring the device to factory default settings
Short-circuit pins 2 and 3 of the DB9 connector and power up the board.
After 1 second the board parameters, including any input calibrations, will be
restored to default settings.
To Next Page
Loading...