Revision 4.02 June. 2000 3
Installing your Model 3000 / Access 4000 system.
Control Module Parts List
- Control Module PCB mounted on metal chassis in metal box.
- Tamper switch bracket.
- Telephone line cable. (Note: Non-standard configuration. Only suitable for use with this product)
- Installation Kit containing:
- 9 x plastic “D” bungs. Must be fitted to all unused cable entry cutouts in the cover.
- 1 x Special AC Powercord entry “D” bung.
- 6 x 8 Way plug-on screw terminals.
- 8 x 2 Way plug-on screw terminals.
- Tamper switch.
- Tamper switch bracket.
- Telecom Line cord.
- 2 x 6.3mm Tamper switch connectors.
- 2 x 4.8mm Battery terminal connectors.
- 1 x 2 Amp M205 (20mm) Fuse. (Spare)
- 20 x 2k2 End-of-line resistors. 16 x Zone Inputs, 4 x Spare. (red-red-black-brown-brown)
- 20 x 6k8 End-of-line resistors. 16 x Zone Inputs, 4 x Spare. (blue-grey-black-brown-brown)
- Spiral bound User Manual.
- User’s Quick Reference Card. (4 page booklet)
- Installation Manual. (This document)
In countries where the Mains input cable is not pre-fitted, the following parts are also supplied:
- 3 x Conductive Sleeves for AC Power cable termination.
- 1 x Plastic Cable grommet.
- Sufficient mounting screws to assemble all parts to housing.
To Next Page
Loading...
