Appendix III 50
•
AUTO mode is only applicable for SM, MM, NZ bers. AUTO mode may not be
able to identify while splicing special bers.
•
Mismatch between estimated splice loss and actual splice loss.
•
The estimated loss is just an estimated number by calculation, for reference
only.
•
The optical components of the splicer need to be cleaned.
•
Fiber protection sleeve does not shrink completely.
•
Extend the heating time.
•
Method to cancel heating process.
•
Press HEAT button to stop during heating process. The LED light will go off
after pressing the key.
•
Fiber protection sleeve sticks to heating plate after shrinking.
•
Use a cotton swab or a similar soft tip object to push and remove the sleeve.
•
Forgot password.
•
Please contact the sales agent.
•
No arc power change after [Arc Calibration].
•
It is the internal parameters that are calibrated and adjusted after arc
calibration. The displayed arc power in each splice mode does not change.
•
Forgot to load bers while execute some specic maintenance function that
bers are needed.
•
Return key is invalid in this case. Open the windproof cover, load prepared
bers in the splicer, and press [SET] to continue or press [RESET].
•
Upgrading failure.
•
When users use the new USB to upgrade, the splice may not be able to identify
the upgrade le correctly. In this case, please re-plug the USB and restart the
splicer.
•
Check if the upgrade le name and the format are correct.
•
Please contact sales agent if you still cannot solve the problem.
•
Other
•
Please refer to the video in the user CD.
Note: Product model and specications are subject to change without prior
notice.
To Next Page
Loading...