Inovance AC700 Series - Ethernet Signal Pins and Display Port

Wiring
-31-
Pin
Signal (Ethernet 1000
Mbps)
Signal Direction
Description
7
– (DD+) – (Bidirectional) Not used (data D+)
8
– (DD-) – (Bidirectional) Not used (data D-)
The definitions of pins 4, 5, 7, and 8 under the Ethernet baud rate of 1000 Mbps differ from those
under 100 Mbps.
4.5 Display Port
The controller provides a standard display port (DP). The specifications of this port are as follows:
Item
Specifications
Signal type Digital DP
Max. resolution
1920 x 1200 @60 Hz
Hot swapping
Supported
Pins of the DP port are defined as follows:
No.
Description Function
1
ML_Lane 0 (p) Lane 0 of the main link: Differential signal
2 GND
3
ML_Lane 0 (n) Lane 0 of the main link: Differential signal
4
ML_Lane 1 (p) Lane 1 of the main link: Differential signal
5 GND
6
ML_Lane 1 (n) Lane 1 of the main link: Differential signal
7
ML_Lane 2 (p) Lane 2 of the main link: Differential signal
8 GND
9
ML_Lane 2 (n) Lane 2 of the main link: Differential signal
10
ML_Lane 3 (p) Lane 3 of the main link: Differential signal
11 GND
12
ML_Lane 3 (n) Lane 3 of the main link: Differential signal
13 GND
14 GND
15
AUX_CH (p) Auxiliary channel: Differential signal
16 GND
17
AUX_CH (n) Auxiliary channel: Differential signal
18
Hot Plug Hot swapping detection
19 DP_PWR Return
DP power return signal
20 DP_PWR
Power supply: +3.3 V