4
Ensure there are no foreign matters on ventilation surface. Failure to comply may result in
Ensure the module is connected to the respective connector securely and hook the module
Wiring
=GXTOT
Wiring must be carried out by personnel who have received the necessary electrical training
and understood enough electrical knowledge.
Disconnect all external power supplies of the system before wiring. Failure to comply may
result in electric shock, module fault or malfunction.
Install the terminal cover attached to the product before power-on or operation after wiring is
completed. Failure to comply may result in electric shock
Perform good insulation on terminals so that insulation distance between cables will not
reduce after cables are connected to terminals. Failure to comply may result in electric shock
or damage to the equipment.
For details, see the wiring section in this guide.
the cables to ground reliably.
Ensure that all cables are connected to the correct interface. Failure to comply may result in
module and external equipment fault.
If the connector is used to connect with external equipment, perform correct crimping or
A label on the top of the module is to prevent foreign matters entering the module. Do not remove
the label during wiring. Remember to remove it before system operation, facilitating ventilation.
Do not bundle control wires, communication wires and power cables together. They must be
run with distance of more than 100 mm. Otherwise, noise may result in malfunction.
Select shielded cable for high-frequency signal input/output in applications with serious
interference so as to enhance system anti-interference ability.
To Next Page
Loading...
Need help?
General
