Inovance H0U Series - Page 56

8 Appendix
55
The keys shown in the table below are basic buttons with their own default functions. But the
basic keys can also be used as custom keys to perform custom functions through controls. When
the default function and custom function of the basic buttons on the same page conflict, you
should set the priority.
The priority of the button is set as: register> menu> custom button> alarm> page switching.
When there are register controls on the page, the buttons related to the register will execute the
register function, not the custom function, even if there is a custom function.
Keys
Button
Basic function description
ESC
On the default page, press this key to enter the main menu.
When an alarm occurs, press this key to return to the page before
occurrence of the alarm.
In the menu mode or parameter edit mode, press this key to return to the
previous operation or discard the current operation.
SET
When an editable register parameter exists and allows edition, press this
key to enter the editing mode.
In the parameter editing mode, press this key to stop editing of this parameter
and go to the next parameter. If there is no next parameter to be edited, the
editing mode will be exited.
If there is no editable parameter or the parameters do not allow edition,
pressing this key is invalid.
Down
In the menu control, if there is a cursor line, press this key to move the
cursor down to the next cursor line. If a parameter is being set, press this
key to increase the value by 1where the cursor is located.
Up
In the menu control, if there is a cursor line, press this key to move the cursor
up to the previous cursor line. If a parameter is being set, press this key to
decrease the value by 1where the cursor is located.
Left
If there is a cursor during parameter or item setting, press this key to move
the cursor left.
Right
If there is a cursor during parameter or item setting, press this key to move the
cursor right.
Confirm
In the menu mode with a cursor line, press this key to go to the next-level
menu or view parameter information of the selected item.
In the parameter editing state, press this key to confirm edition of the
parameter and enter the editing state of the next parameter.
Numbers 0–
9
Press these keys to enter the corresponding number when setting
parameters.
+/-
Press this key to set the positive or negative value of the data.
CLR
Press this key to clear the setting.