5 Create and download project
5
In this example, there are two modes, new project and temporary project can be selected, the
PLC type is selected as "H0U-XP", and the default editor is ladder diagram. After the selection is
completed, click the "OK" button in the dialog box, a new project is created, and the main
program is opened by default to enter the program programming state, as shown in the following
figure:
※ For more information about the operation guidance of AutoShop software, please refer to the
"Help" of AutoShop software and the "Inovance H1U\H2U PLC Instruction and Programming
Manual" separately issued by Inovance.
To Next Page
Loading...
