- 120 -
Setup
value
Function Description
command
switching
terminal
switching between terminal control and keyboard control
via this terminal.
When the command source (F0-02) is set to 2, it performs
switching between communication control and keyboard
control via this terminal.
21
Speed-up/spe
ed-down
inenabled
Protect the driver from affecting by the external signals
(except stop command), and maintain the current
frequency.
22 Reserved －
23 Reserved －
24 Reserved －
25 Reserved －
26 Reserved －
27 Reserved －
28 Reserved －
29
Torque
control
inenabled
The torque control of driver is inenabled.
30 Reserved －
31 Reserved －
32
DC brake
command
This terminal is enabled, and the driver directly switches to
the DC brake status.
33
External fault
normally
closed input
After the external fault signal is sent to the driver, the driver
reports fault and stops.
Attached Table 1 MS Speed Function Description
K
4
K
3
K
2
K
1
Frequency Setup
Correspondi
ng Parameter
OFF OFF OFF OFF MS speed 0 FC-0
OFF OFF OFF ON MS speed 1 FC-01
OFF OFF ON OFF MS speed 2 FC-02
OFF OFF ON ON MS speed 3 FC-03
OFF ON OFF OFF MS speed 4 FC-04
OFF ON OFF ON MS speed 5 FC-05
OFF ON ON OFF MS speed 6 FC-06
OFF ON ON ON MS speed 7 FC-07
To Next Page
Loading...
